Welcome OUBAO factory,come to understand our strength.
Professional kitchen faucet R&D and Manufacturing
Not Just Water
Home / News / Faucet Maintenance /

Common Faults and Repair Methods of Bathroom Faucets

Common Faults and Repair Methods of Bathroom Faucets

Issue Time:2021-06-25
the common faults and repair methods of bathroom faucets

When we repair the bathroom faucet, we must determine the specific cause of its failure, and then carry out targeted repairs, instead of blindly disassembling the faucet for an operation to prevent damage to the internal structure of the faucet. The following are the common faults and repair methods of bathroom faucets.

1. Damaged core pulling

If the shaft cushion of the bathroom faucet is worn out for a long time, you can directly use handy pliers to tighten the gland of the faucet and rotate it counterclockwise until it is loosened and removed. Then you can directly take out the worn out. Replace the shaft gasket with the new prepared shaft gasket, and then clamp it tightly with pliers. Tighten the gland bolt in a clockwise direction. The leaking faucet can be used again.

2. The water stop tape is damaged

Use a wrench to rotate the bathroom faucet counterclockwise until it is loosened and take it off, and then use the threaded hole to wind the wind-printed tape clockwise about five or six times. Pay attention to the twisting force to make it fit tightly. For the threaded hole of the bathroom faucet, after finishing this step, continue to re-tighten the faucet in a clockwise direction with a wrench, and then turn on the switch to see if there is any leakage of the faucet. If not, the faucet is restored.

3. The joint of the faucet is worn out

Use pliers to loosen the cap nut of the bathroom faucet in a counterclockwise direction, and then tighten it clockwise to try if there is still water leakage from the faucet. If not, it proves that it is only because the cap nut of the faucet is loose and the water is leaking. . If there is still water leakage, it is recommended that you can directly replace the new u-shaped gasket, and then tighten the faucet clockwise, under normal circumstances it will not leak again.

4. The water faucet has a fork or the water volume is reduced, and there are no air bubbles

It may be that the filter of the bubbler is fouled or clogged with dirt such as debris and scale. We need to remove the faucet with a special tool to clean the filter.

5. Temperature adjustment is not easy and the water temperature often fluctuates

The possible reason is that the pressure difference between the cold and hot water is too large, or the water temperature of the water heater is not that long. We can adjust the hot and cold triangle valve to make the pressure balance to ensure that the water temperature of the water heater can be balanced with its water output speed.

And we also need to observe the specific types of faucets when repairing them. For example, hot and cold faucets are very different from pressing faucets in the repair process. If you want to know more about bathroom faucets after reading the above, you can contact us for more detailed solutions.

As a professional manufacturer of faucets and accessories, we have won praise and trust from many customers with our high-quality products and services. We have a professional production department and have established a strict quality inspection system, which can control the quality of products in an all-round way. At the same time, we will also provide thoughtful services and develop effective solutions according to customer needs. If you want to buy our bathroom faucets, please contact us immediately!